AC, Furnace & Plumbing Services in St. Charles, MO

# Electrical Maintenance - Home Audit Conducted a complimentary electrical safety inspection of residential premises, examining outlet conditions, wiring connections, and LED lighting installations. Documented kitchen backsplash outlet with illuminated indicator light and power cord connections, as well as garage LED strip lighting installation with visible wiring along wall-ceiling junction. All observed electrical components were photographed for record-keeping purposes.

Responded to no cooling call on residential air conditioning system. Upon arrival, found outdoor condenser unit with heavily soiled coil fins showing significant dirt and debris accumulation, restricting airflow. Indoor air handler exhibited extensive age-related deterioration with corroded galvanized metal panels. Performed diagnostic evaluation of system components and confirmed operational status. Condenser coil cleaning was necessary due to substantial environmental contamination affecting heat transfer efficiency. System restored to proper cooling operation following service intervention.

Performed evaporator coil cleaning service on HVAC air handling unit. After consulting with customer regarding service level options, completed Level 1 coil cleaning to remove accumulated dust and debris from the finned heat exchanger surfaces. System coil now cleaned and operational.

Responded to no cooling call on 12-year-old Trane XL 18i outdoor unit. Upon inspection, confirmed outdoor unit was not operating. Diagnosed failed compressor with seized windings and added equipment to maintenance agreement for continued service coverage.

Completed comprehensive cooling tune-up on single outdoor ground-mounted AC unit of unknown age. Performed standard diagnostic testing using digital multimeter, recording temperature readings of 67.7°F and electrical measurements of 0.03 AC volts to verify proper system operation and electrical integrity.

Completed cooling season tune-up on 5-year-old ground-level AC unit located in basement. Performed comprehensive system inspection including electrical connections, refrigerant levels, and airflow verification. Replaced air filter with new pleated media filter and documented equipment condition with photos of blower assembly and control board.

Completed cooling system tune-up on a residential outdoor unit over 10 years old located in backyard. Performed comprehensive maintenance inspection of all electrical components, circuit board, and wiring connections. Inspected and replaced dirty air filter to restore proper airflow and system efficiency.

Completed comprehensive cooling system tune-up on 8-year-old ground-level outdoor unit. Performed standard maintenance protocol including system diagnostics, temperature differential measurements, and replaced air filter with new pleated media filter. All components inspected and found operating within normal parameters.

Replaced outdated 60-amp exterior disconnect with new 45-amp fused disconnect for HVAC system. Removed old unit, installed replacement disconnect box on exterior wall with proper conduit connections, and disposed of failed equipment. System tested and confirmed operational upon completion.

# HVAC Cooling System Tune-Up Completed Performed comprehensive preventive maintenance tune-up on a one-year-old residential air conditioning unit located in the backyard. Conducted thorough inspection of the system's control cabinet, accessing internal electronic components including circuit boards, pressure switches, and wiring connections. Verified proper operation of all control sequences and safety devices within the furnace panel. Utilized digital multimeter to perform electrical diagnostics, measuring voltage and amperage readings to ensure system is operating within manufacturer specifications. All electrical measurements fell within acceptable parameters. Inspected wire connections, securing loose wiring with appropriate fasteners and verifying all terminations were tight and secure. Examined control board components, capacitors, and integrated circuits for signs of wear or damage. All electronic components showed normal operation with no visible defects. Pressure switch an

Replaced antiquated 50-gallon gas water heater with new 50-gallon tall gas unit in basement location. Verified incoming water pressure to residence and installed 3/4" pressure reducing valve as part of installation to protect plumbing system. Connected all supply and discharge lines, installed proper venting through existing infrastructure, and ensured all safety devices and temperature/pressure relief valve were properly installed and operational. Unit tested successfully with no leaks detected at any connections.

Completed installation of 40-gallon tall gas water heater in basement utility area, replacing unit that was over 30 years old. New water heater was positioned in existing location adjacent to furnace and HVAC equipment, with all gas connections, water supply lines, and venting properly installed per manufacturer specifications and local code requirements. All safety labels and warning stickers were verified to be visible and intact on installed unit.

Completed comprehensive cooling system tune-up on single outdoor condensing unit located at side of residence. Performed standard preventive maintenance procedures including electrical diagnostics using digital multimeter to verify capacitor functionality, voltage readings, and overall system performance. All components inspected and found operating within normal parameters; unit tested and left in proper working condition.

Performed comprehensive cooling maintenance tune-up on 3-year-old Lennox air conditioning system. Conducted thorough inspection of all major components including control board, electrical connections, and wiring harness. Verified system operational parameters using digital multimeter, confirming proper voltage readings and electrical performance. System found to be functioning properly with no deficiencies noted at time of service.

Responded to no heat call and performed system inspection. Found heavily soiled air filter restricting airflow to furnace, causing system shutdown due to limit switch activation. Replaced dirty 16x25x1 filter with new unit, restored proper airflow, and verified system operation. Unit returned to normal heating function with adequate airflow and proper temperature rise across heat exchanger.

Completed complimentary electrical inspection of main service panel and distribution system. Documented current panel configuration showing dual columns of circuit breakers with main disconnect switches, verified panel directory labeling on interior door, and assessed overall system condition. Photographed wire management and cable routing above panel box to document existing installation for homeowner records.

Completed comprehensive cooling season tune-up on Lennox condensing unit located on side of home. Performed full system inspection including control board diagnostics, electrical connections verification, refrigerant level assessment, condenser coil cleaning, and fan motor operation testing. All components found operating within manufacturer specifications; system ready for cooling season.

# HVAC Tune-Up U10 Completed Performed comprehensive preventative maintenance tune-up on an 8-12 year old residential HVAC system for Home Depot service order #F58221836. Accessed air handler unit located in attic space and inspected return air grille, ductwork connections, and insulation integrity. Conducted exterior condenser unit inspection, cleaned coil fins, verified proper drainage around equipment pad, and performed temperature differential measurements to confirm system operating efficiency. Unit showed normal wear consistent with age with no accessories requiring attention. All standard tune-up protocols completed per U10 service specifications.

Responded to no cooling complaint on aging outdoor condenser unit located in side yard. Upon arrival, found unit with significant environmental wear, debris accumulation, and biological growth on surrounding surfaces. Performed diagnostic evaluation of system operation, inspected condenser coil condition through protective grille, and assessed electrical components including disconnect box. Documented equipment condition showing weathered exterior casing, darkened metal grating from oxidation, and dirt buildup affecting unit performance. Identified contributing factors to warm air discharge and provided recommendations for necessary repairs to restore proper cooling function.

Responded to a no heat call for two HVAC units located in the basement, both under 10 years old. Upon inspection, found the return air filter severely clogged with dust and debris, restricting airflow to the system. Replaced the heavily soiled filter and verified proper system operation. Thermostat was functioning correctly and displaying accurate temperature readings. System restored to normal heating operation with improved airflow.